KEB F6 Series User Manual

4. Navigate to the desired parameter and press F1 (‘Select’ function)
to display the parameter in the selected position.
5. The screen is updated and now displays the parameter in the
selected position.
Figure 38: Parameter select screens
Adjusting the screen using this procedure will update the non-volatile memory,
saving the parameters through boot, but does not automatically update the
default le. To update the default le, see the Default options screen section.
49
SCREEN OVERVIEW

KEB F6 Series Specifications

General

Communication Interfaces	RS-485, Modbus RTU, CANopen
Protection	Overcurrent, overvoltage, undervoltage, short circuit
Operating Temperature	-10°C to +40°C
Humidity	Up to 95% relative humidity, non-condensing
Control Modes	sensorless vector control (ASCL), closed-loop vector control (encoder feedback)