This image shows what MIDI data will output for each sensor in the “Ableton Live Clip
Launching” and “LaunchPad Emulator” preset. In this preset the Pads use Grid Mode. This
preset doesn’t use banks. Rotaries are set to use Direction instead of Location. Velocity
response is fixed at 127 for all notes. All Pressure sources send out continuous CC values.
In this preset, the LEDs will not light up because Local LED Control is turned off. This is so
the Ableton Live template’s Remote LEDs will have full control over the LEDs.
For more information about using the Ableton Live Template or the LaunchPad Emulator
Template, read the corresponding Quickstart document included in the QuNeo Software
Template Installer.
21
To Next Page
Loading...