Transport Edit Pane
The Transport buttons are the 3 buttons at the top of the
QuNeo next to the Mode button. The diamond button with
the red LED is the record button, the square button with the
yellow LED is the stop button, and the triangular button with
the green LED is the play button.
Assign the Channel, Note, and Pressure CC# for each
Transport button in the Basic tab. To disable a source, set
the number box below 0 to “off” (-1).
Notes and Pressure CC#s can be set to Normal or Toggle
mode and utilize Velocity/CC output number boxes for
added functionality. See the Normal and Toggle Modes
chapter for more information.
Sensitivity can be adjusted at the very bottom of the edit
pane (see the Sensitivity chapter).
The Transport buttons do not have Advanced tabs. For
information about the LEDs tab, reference the LEDs Tab
chapter.
Left/Right Buttons Edit Pane
The Left/Right buttons are positioned to the left of each
Horizontal slider. If the “Enable Bank Switching” box is
checked, these button pairs act as bank controls for each
Horizontal Slider. See the Vertical and Horizontal Slider Edit
Pane chapter for more info. The banks will be indicated by
the LEDs of the 2 buttons.
For information about how the LEDs indicate the banks, see
the Banks chapter of this manual.
If Bank Switching is disabled, each button can output an
assigned Note or Pressure CC#. To disable a source, set
the number box below 0 to “off” (-1).
Notes and Pressure CC#s can be set to Normal or Toggle
mode and utilize Velocity/CC output number boxes for
added functionality. See the Normal and Toggle Modes
chapter for more information.
Sensitivity can be adjusted at the very bottom of the edit
pane (see the Sensitivity chapter).
The Left/Right buttons do not have Advanced tabs. For information about the LEDs tab,
reference the LEDs Tab chapter.
53
To Next Page
Loading...
Need help?
General