3.8.5 MIDI Channel
3.8.6 Channel Rotation
3.8.7 Toggle
3.8.8 Transpose
3.8.9 LEDs Local/Remote
3.8.10 Program Change
3.8.11 Bend Range
3.8.12 Key Priority
3.9 Controller Layer
3.9.1 Sensor Settings
3.9.1.1 Participate
3.9.1.2 Controller Layer Sources
3.9.1.3 Controller Layer Toggle
3.10 CV Layer
3.10.1 CV Output (MIDI to CV)
3.10.2 CV Input (CV to MIDI)
3.10.3 CV Trims
Chapter 4 Troubleshooting
4.1 Connectivity Trouble
4.1.1 Touchy USB Connection
4.2 CV Trouble
4.2.1 Steps to Convert MIDI to CV
4.2.2 Audible High Pitched Noise in Computer Audio when using CV
4.2.3 QuNexus LEDs Light Up Erratically When Receiving CV
4.3 Firmware Trouble
4.3.1 QuNexus Doesn’t Do Anything After a Firmware Update
4.3.2 Firmware Update Freezes or Doesn’t Work
4.3.3 General Firmware Information and Suggestions
4.3.3.1 Unplug Other USB Devices
4.3.3.2 Try a New Micro-USB Cable
4.3.3.3 “Hotplugging” on Windows
4.3.3.4 Don’t Send MIDI to QuNexus During an Update
4.3.3.5 If Things are Working Fine, DON’T Update Right Before your Show
4.3.3.6 Manually Updating Firmware
Safety Precautions
4
To Next Page
Loading...
