Keith McMillen Instruments QuNexus Reference Manual

3.9 Controller Layer
The Controller Layer tab appears next to Keyboard Layer. Here you can assign each key its
own additional Note, Toggle CC#, Pressure CC#, and Tilt CC#. Do this by clicking on any key in
the image so that it is highlighted with a green border. Then look below the image at the Sensor
Settings.
Tip: CV Layer does not convert MIDI Messages from Controller Layer.
3.9.1 Sensor Settings
Here you can decide what to enable for the highlighted Key. There are number boxes for
choosing which Note Numbers and CCs to use and what their behavior will be. You can choose
whether the key participates in Keyboard Layer, Controller Layer, or both. You can also set the
Channel number and the output device.
45

Keith McMillen Instruments QuNexus Specifications

General

Brand	Keith McMillen Instruments
Model	QuNexus
Category	Electronic Keyboard
Language	English