2. Download or locate the firmware file you would like to install, along with the “Enter
Bootloader” sysex command file (zip files for your current version can be downloaded
here: http://files.keithmcmillen.com/downloads/qunexus/sysex_files/)
3. Plug in your QuNexus and open SysEx Box
4. Select QUNEXUS Port 1 (or Port 1) in the MIDI In and MIDI Out ports
5. Click “Open Sysex File”. When the browser window opens, navigate to the enter
bootloader file (typically named “enter_bootloader.syx”) and click “Open”
6. Click the “Send Sysex” button - the blue shift button on your QuNexus should light up
solid. Your QuNexus is now in bootloader mode and ready to receive firmware
7. Make sure the MIDI In and MIDI Out ports still say QuNexus
8. Click “Open Sysex File” again. This time select the firmware file you want to send to your
QuNexus, then click “Open”
9. Click the “Send Sysex” button - the blue shift button on your QuNexus should start
flashing. The firmware update will take a moment.
10. Once the update is complete the LEDs on your QuNexus should swipe across the board
as though it is powering on. Your firmware has been updated!
62
To Next Page
Loading...
Need help?
General
