Keith McMillen Instruments SoftStep3 - Display Modes; LED Modes

SoftStep advanCed editor
35
SoftStep3
diSplay ModeS
You can set how the “Key Name is displayed on the SoftStep display with the “Display Mode”
none
Has no effect on the SoftStep display� Stepping on a key with None selected will show the current
preset name�
alWayS
Displays the key name whenever the key is pressed. The key prex and parameter value are not used
in this mode�
onCe (hoSted Mode only)
The key name will be displayed as soon as the key is pressed for the rst time, after a brief period the
prex and parameter value will be displayed. Any subsequent key presses will display the prex and
parameter value�
initial/retUrn
The key name will be displayed as soon as the key is pressed. After a brief period the prex and
parameter value will be displayed�
iMMed paraM
Displays the key’s prex and parameter value whenever the key is pressed.
led ModeS
The LED mode denes how the SoftStep’s LEDs behave. Tell them when to turn on, when to turn off, and
more� Each of the following options are available in the Advanced Editor for both the green and red LEDs:
none
Has no effect on the LED state� If the LED is currently on, it will stay on — if it’s off, it will stay off�
trUe
The LED will turn on when the modline value is 1 or greater� It will turn off when the modline value is
equal to 0�
falSe
The LED will turn on when the modline value is equal to 0� The LED will turn on when the modline
value is 1 or greater�
flaSh trUe
The LED will continuously ash when the modline value is 1 or greater. It will turn off when the modline
value is equal to 0�