Keith McMillen Instruments SoftStep3 - Output Settings; Message Type

SoftStep advanCed editor
30
SoftStep3
oUtpUt SettinGS
The Output Settings section is where you set the MIDI Message Type that will be sent, and the Output Port it
will be sent on�
MeSSaGe type
Message Types select what kind of MIDI message the modline will output (there are also a couple of other
message types, but MIDI is the most common)�
Each Message Type has options that further dene how the message type should behave — e.g. what MIDI
note number and velocity to output, what CC number to send on, or what channel to output program
change values on�
The following Message Types are available:
none
No message will be output� This is helpful if the modline is only controlling LED behavior or being
further processed using one of the Modline 1-6 Output sources�
note Set
Outputs a MIDI note with a specied velocity. A positive value will send a Note On message, a value of
0 will send a Note Off message� The following options are available when Note Set is selected:
Note - Sets the note number to be output�
Vel - Sets the velocity value to be output with the note on messages�
Ch - Sets the MIDI channel to output the note messages on�
note live
Outputs MIDI notes with a specied velocity. The note number is determined by the values coming
through the modline� The following options are available when Note Live is selected:
Vel - Sets the velocity value to be output with the note on messages�
Ch - Sets the MIDI channel to output the note messages on�
CC
Outputs values on a specied Control Change (CC) number. The following options are available when
CC is selected:
CC# - Sets the CC number to send the messages on�
Ch - Sets the MIDI channel to output the CC messages on�