SoftStep advanCed editor
31
SoftStep3
bank
Outputs values as MIDI bank select messages� The following options are available when Bank is
selected:
MSB - Sets the MSB of the bank message�
Ch - Sets the MIDI channel to output the bank select messages on�
Note: Bank Select messages are 14-bit resolution (a range of 0-16383), as opposed to the standard
7-bit MIDI message (range 0-127)� This is accomplished by using two separate messages: a MSB (most
signicant bit) and an LSB (least signicant bit). With SoftStep, values passing through the modline will
set the LSB of the bank message — the MSB must be xed at a specied value (using the MSB option).
proGraM
Outputs values as MIDI program change messages� The following options are available when Program
is selected:
Ch - Sets the MIDI channel to output the program change messages on�
pitCh bend
Outputs values as MIDI pitch bend messages�
• 0 = full bend down
• 64 = center (no bend)
• 127 = full bend up
The following options are available when Pitch Bend is selected:
Ch - Sets the MIDI channel to output the pitch bend messages on�
MMC
Used to send MIDI Machine Control (MMC) messages� The following options are available when MMC
is selected:
ID - Sets the device ID number for the MMC message� Each MMC-capable device should have a
unique ID number (most devices/software allow the user to set the ID number in case of conicts).
Function - Sets the MMC function/command that should be sent� The following MMC commands
are available:
• Stop
• Play
• Deferred Play
• Fast Forward
• Rewind
To Next Page
Loading...