Keith McMillen Instruments SoftStep3 - Page 32

SoftStep advanCed editor
32
SoftStep3
• Punch In
• Punch Out
• Pause
oSC (hoSted Mode only)
Outputs values as an OSC message with a specied prex. OSC settings such as input port, output
port, output IP address can be set in the OSC tab of the Settings window� The following options are
available when OSC is selected:
Output Prex - Sets the prex to output with the OSC message. A prex typically begins with a
“/” character, e.g. /softstep or /controller. Defaults to “/softstep” (no quotes) when no prex is
specied.
aftertoUCh (hoSted Mode only)
Outputs values as MIDI aftertouch messages� The following options are available when Aftertouch is
selected:
Ch - Sets the MIDI channel to output the aftertouch messages on�
poly aftertoUCh (hoSted Mode only)
Outputs values as MIDI polyphonic aftertouch messages� The following options are available when
Poly Aftertouch is selected:
Note - Sets the note number to associate with the poly aftertouch message�
Ch - Sets the MIDI channel to output the poly aftertouch messages on�
y inC Set (hoSted Mode only)
Sets a key’s Y Increment value� Any value going through the modline will instantly set the current key’s
Y Increment value� Useful for initializing Y Increment values from other keys or preset changes�
x inC Set (hoSted Mode only)
Sets a key’s X Increment value� Any value going through the modline will instantly set the current key’s
X Increment value� Useful for initializing X Increment values from other keys or preset changes�