Keithley 2790 - Page 127

M
Manual cable discharge 2-18
Math 2-9
matrix backplane and guard terminals 2-5
Memory 2-21, 2-22, 2-23, 5-30
memory 2-20
Memory patterns, setting up 2-21
Model 7700, 7702, and 7703
Introduction A-1
Model 7702 3-1
Ω2-Wire and Thermistor connections 3-5
Ω4-Wire and RTD connections 3-6
Channel assignments 3-9
Connection Log 3-7
Current connections (AC or DC) 3-6
opening and closing channels 3-9
screw terminal channel designations 4-6
Typical connections 3-5
Viewing closed channels 3-12
Voltage connections (DC or AC) 3-7
Wiring procedure 4-4
Model 7751/7752 2-1
interlock 2-16
manual cable discharge 2-18
Screw terminal channel designations 4-5
Viewing closed channels 2-15
Wire dressing 4-7
Wiring procedure 4-4
Module 4-10
Multiple channels
Control commands 2-8, 2-12, 2-14,
3-11, 6-5
operation 2-13
O
ohms math function 2-11
OPEN key 3-10, 3-11
Opening and closing channels
Model 7702 3-9
Model 7751/7752 2-13
operation
multiple channel 2-13
Overview 1-1
oxide build-up 1-7
P
PLC 1-5
Power 4-10
primary tests 1-6
programmable
logic controller 1-5
voltage source 2-4
Programming errors 2-12
Q
quick-disconnect terminal blocks 2-5
R
Remote programming 2-8, 2-11
errors 2-16
opening and closing channels 2-14, 3-11
view closed channels 2-15
RS-232 1-5, 5-4
S
Safety warnings 2-6
Screw terminals 4-2
Serial bus (RS-232) 1-5, 5-4
Setting 2-21
shield (zipper tube) 4-8
short circuit current 2-6
Shunt bar test 1-6, 1-7
inflator testing 5-10
Simplified schematic
Model 7702 3-4
Models 7751 and 7752 2-3
Slot numbering 2-13, 3-9
Source
output levels 2-6
outputs and guard terminals 2-5
readback 2-5
tracking 2-11
Specifications A-1
SxIohms 2-9
SxVohms 2-10
System connections 1-5, 5-3