Keithley DMM6500

Section 4: TSP command reference Model DMM6500 6½-Digit Multimeter with Scanning Calibration and Adjustment Manual
4-4 DMM6500-905-01 Rev. A/July 2018
cal.adjust.step.execute()
This function executes the specified adjustment step.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
cal.adjust.step.execute(stepname)
cal.adjust.step.execute(stepname, value)
stepname
The adjustment step to start
value
Value for this adjustment step. If using the default then value is optional
Details
This command generates an error if:
• Calibration is locked
• The step does not complete successfully
• The value that is passed is invalid for the step, out of range, or not needed
Also see
cal.lock() (on page 4-5)
cal.unlock() (on page 4-8)