There is a fuse holder in the control cabinet of the product (Pos. 1). The
signal horn is switched off by folding down (Pos. 2) the fuse holder (Pos. 1).
Switching off the signal horn also deactivates the error message on the
control display. The signal horn must be reactivated after replacing the
filter.
7.4 Emergency measures
In case of fire of the product or its detection elements, the following steps
should be taken if necessary:
1. Where possible, disconnect the product from the power supply by
unplugging.
2. If present, disconnect the compressed air supply.
3. Fight fire with a commercially available dry powder extinguisher.
4. Notify local fire brigade if necessary.
To Next Page
Loading...
