MasterTig 535ACDC
Operating manual - EN
2.11 Lifting MasterTig 535 equipment
If you need to lift the MasterTig 535 welding equipment, pay special attention to the safety measures. Also follow the
local regulations.
Connect the 2-legged chain or strap from the hoist hook to the two lifting eyes on the power source.
Ensure the chain or strap is long enough to avoid excessive lateral load on the lifting eyes.
Do not attempt to lift the equipment with a hoist from the handle on the power source. The handle is for moving the
equipment when installed on cart.
© Kemppi
28
1921940 / 2140
To Next Page
Loading...
Need help?
General
