Kemppi MasterTig 535ACDC - 3.2.5 Pulse view

MasterTig 535ACDC
Operating manual - EN
Parameter Value Note
Post gas
0.0 s ... 30.0 s / Auto, step 0.1 s (Default =
Auto)
Adjustable parameters in MicroTack welding:
Parameter Value Note
Pre gas
0.0 s ... 10.0 s, Auto, 0.1 s step (Default =
Auto)
MicroTack spot count
1 ... 5 / Continuous, step 1 (Default = 1) If Lift TIG is used, MicroTack graph shows
only 1 spot and the spot count para-
meter is not visible.
MicroTack spot time
1 ms ... 200 ms, step 1 ms (Default =10
ms)
MicroTack pause time
10.0 ms ... 100 ms, step 1 ms (Default = 50
ms)
0.2 s ... 2.0 s, step 0.1 s
This is not visible in the settings if the
MicroTack pulse count is only 1.
Post gas
0.0 s ... 30.0 s / Auto, step 0.1 s (Default =
Auto)
"Welding processes and features" on page62
3.2.5 Pulse view
© Kemppi
41
1921940 / 2140