MasterTig 535ACDC
Operating manual - EN
1. GENERAL
These instructions describe the use of Kemppi's MasterTig 535ACDC welding power source. The system consists of
MasterTig power source with MTP35X control panel (factory installed), optional MasterTig Cooler MXL water cooler,
optional transport unit and Flexlite TX TIG welding torch.
Important notes
Read the instructions through carefully. For your own safety, and that of your working environment, pay particular atten-
tion to the safety instructions delivered with the equipment.
Items in the manual that require particular attention in order to minimize damage and harm are indicated with the
below symbols. Read these sections carefully and follow their instructions.
Note: Gives the user a useful piece of information.
Caution: Describes a situation that may result in damage to the equipment or system.
Warning: Describes a potentially dangerous situation. If not avoided, it will result in personal damage or fatal injury.
DISCLAIMER
While every effort has been made to ensure that the information contained in this guide is accurate and com-
plete, no liability can be accepted for any errors or omissions. Kemppi reserves the right to change the spe-
cification of the product described at any time without prior notice. Do not copy, record, reproduce or transmit
the contents of this guide without prior permission from Kemppi.
© Kemppi
4
1921940 / 2140
To Next Page
Loading...
Need help?
General
