Kemppi X8 MIG User Manual

X8 MIG WELDER 2.4 Operation
Wired connection
The Ethernet connection is automatically created when you connect the Ethernet cable to X8 MIG
Welder. The Ethernet connection details are shown in Ethernet settings when the connection is created.
Set DHCP to OFF to configure the Ethernet settings manually.
Cloud services status
The different icons for cloud services are in the table below.
OPERATING MANUAL | EN 109
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English