Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
Earth return cable
2.3.5 Control Pad installation
This chapter describes the control pad installation.
For information on operating Control Pad, see Control Pad on page 84.
2.3.5.1 Wireless connection
Control Pad connects wirelessly to X8 Wire Feeder. If there are two wire feeders in the system, choose which
one to connect to. Control Pad can be connected to X8 Power Source in applications where no wire feeder is
needed, such as stick welding or gouging.
To set up a wired connection between Control Pad and the power source or the wire feeder, see Wired
connection on page 57.
If Control Pad is not connected, you see this info message on the display.
Proceed as follows:
1.
To connect Control Pad wirelessly to a wire feeder or power source:
a) Press the wireless pairing button on the power source indicator panel.
OPERATING MANUAL | EN 55
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English