X8 MIG WELDER 2.3 Installation
1.
Loop two lifting straps through the handle at the front and two straps through the handle at the back of
the power source.
Caution:
Place the straps as close to the power source as possible.
2.
Lift steadily straight up.
2.3.8 Purchasing and managing welding software
You can purchase Kemppi welding software licenses to X8 MIG Welder. Installed licenses can be viewed with
Control Pad.
For more information, visit www.kemppi.com.
2.3.9 Optional accessories
X8 MIG Welder has several accessories to facilitate its use and improve welding quality.
Wire Drum Kit
To use the wire drum kit, drill a hole at the back of X8 Wire Feeder's transparent cover.
OPERATING MANUAL | EN 79
©
KEMPPI | 2018-09-28
To Next Page
Loading...
Need help?
General
