Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
2.
Push the rear axle through the opening in the bottom of the rear side of the unit and set the axle in the
middle.
3.
Slide the two wheel spacers (1) onto the axle.
4.
Slide the two wheels (2) onto the axle.
5.
Slide the two washers (3) onto the axle.
6.
Slide the two retaining rings (4) on the axle, until they lock into the groove on the axle.
1 2 3 4
Install the front wheels:
7.
Push the front axle through the opening in the bottom of the front side of the unit and set the axle in
the middle.
OPERATING MANUAL | EN 27
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English