Kemppi X8 MIG User Manual

X8 MIG WELDER 2.3 Installation
1.
Place the wire feeder rotating plate or double rotating plate on top of the power source, with the orange
claw at the rear of the unit.
2.
Pull the release lever at the front of the wire feeder rotating plate, and turn the top sideways to allow
access to the bottom half.
3.
Attach the bottom of the wire feeder rotating plate to the power source with four screws (1) and
washers (2).
OPERATING MANUAL | EN 35
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English