X8 MIG WELDER 2.3 Installation
2.
Replace the contact tip adapter/gas diffuser , if needed. Screw in and hand-tighten the new adapter as
tight as possible (no tool is needed).
Note:
It is important to tighten the adapter properly to enable a tight connection of the contact tip to
the gun.
3.
Screw in a new contact tip and tighten it properly with a tool. Some thread grooves on the contact tip
remain visible when the contact tip is properly connected to the gun.
OPERATING MANUAL | EN 75
©
KEMPPI | 2018-09-28
To Next Page
Loading...
Need help?
General
