Pump operations are stopped
until the error is resolved.
This indicates information only,
Attaching the A/C Adapter Power Cord
Plug the Power Cord into the A/C Adapter Port on the back of the pump. See Figure 1A to locate port on pump. Make
of the location of the pins and tab on the plug to properly orient the plug.
The connector, which attaches to the back of the pump, has a spring-loaded locking sleeve that locks into the pump, thus
helping to prevent the connector from being accidentally knocked out. To remove the connector, grasp the outer sliding
sleeve member and pull. Do not detach the connector by pulling on the cord only.
The battery pack is fully charged before shipping, and is left unconnected to optimally preserve battery life.
The battery should be connected before using the pump.
It is also recommended that the battery charge be “topped off” before battery-only operation is utilized. The battery pack
will charge continuously whenever the pump is plugged into a wall outlet, including during normal use of the pump with
Eight hours of charging is required to fully recharge the battery pack.
A new battery pack will provide approximately 15 hours of service before needing to be recharged.
© 2005 Tyco Healthcare Group LP
To Next Page
Loading...