Chapter 2
CONNECTING THE TESTER
The Tester must be powered by a 230V supply.
The supply must include an earth connection via a 3 pin mains plug.
When switched on, the Tester will carry out a short self-test procedure
(approximately 2 seconds). During this test, the following screen will appear:
Note
Current revision numbers are shown at the bottom of the screen.
The Tester will then display the Main Menu.
Chapter 3
USING THE TESTER
Introduction
Once the start-up procedure of the Tester has been completed, the following
screen will appear: -
USER : John
Thursday 4 March 2011 09:03
Navigation through the menus is by dedicated keys: -
There are also the five Fast keys down below the display whose action will
change depending on the function of the Tester at any particular point.
To select an option from the Main Menu, use the cursor keys. The selected
option will be displayed in inverse video. The highlighted option is selected
by pressing the Green button or Return key.
CONNECTING THE TESTER
USING THE TESTER
To Next Page
Loading...
