CLEANING THE TESTER
CHAPTER 5 MAINTAINING THE TESTER
Cleaning the Tester
The Tester case can be cleaned with a damp cloth, with if necessary, a
small amount of mild detergent. Prevent excessive moisture around the
socket panel or in the lead storage area.
Do not allow liquid inside the Tester, or near the sockets panel. Do not use
abrasives, solvents, or alcohol.
If any liquid is spilt into the Tester case, the Tester should be returned for
repair, stating the cause of the defect.
USER MAINTENANCE
User Maintenance
The Tester is a rugged quality instrument. However, care should always be
taken when using, transporting and storing this type of equipment. Failure
to treat the product with care will reduce both the life of the instrument and
its reliability.
If the Tester is subject to condensation, allow the Tester to completely dry
before use.
Always check the Tester and all test leads for signs of damage and •
wear before use.
Do not open the Tester under any circumstances.•
Keep the instrument clean and dry.•
Avoid testing in conditions of high electrostatic or electromagnetic •
fields.
Maintenance should only be performed by authorised personnel.•
There are no user replaceable parts in the Tester.•
The unit should be regularly calibrated (at least annually).•
For repair or calibration return the instrument to Kewtech at:-•
The Service Department
Kewtech Corporation Ltd
Unit 2, Shaw Wood Business Park
Shaw Wood Way
Doncaster
DN2 5TB
Tel: 01302 761044
Fax: 01302 321993
Email: sales@kewtechcorp.com
To Next Page
Loading...
Need help?
General
