HOW TO PRINT BARCODE LABELS AND TESTCODESHOW TO PRINT BARCODE LABELS AND TESTCODES
Change Password
It is possible to Password protect the TEST SEQUENCE EDITOR and the
SYSTEM CONFIGURATION
If you currently do not have password protection you will be asked to enter
a new password twice, once for confirmation.
If you currently do have password protection then you will be asked for the
old password before entering a new one, again you will be asked for the
new password twice.
To clear the password protection simply press Enter when asked for the
new password. Or set the field to ‘blank’ (i.e. all spaces) if a password was
previously set.
Set Brightness
You can set the Brightness of the display. Use the cursor keys to change the
Brightness, once the Brightness is set press the Green button to accept the changes.
Press the Red button to abort any changes made.
Factory Settings
It is possible to reset the Kewtech KT77 to the settings which were configured from
new. This option will first ask you if you are sure, select Yes to reset or No to abort.
Caution
This will restore all lists to default settings including SITE LIST, LOCATION
LIST, USER LIST and TEST SETTINGS
How to use the Memory
To use the memory tests and functions, use the cursor keys to highlight the MEMORY
OPTIONS on the Main Menu and press Enter to display the following menu:-
Use the cursor keys to highlight a test or function and press Enter to select the
desired option.
View Memory Used
The Tester allows the user to see how much of the results memory is being used.
The following bar graph of the memory remaining is displayed:-
Perform Memory Test
To Next Page
Loading...
Need help?
General
