Keysight Technologies AC6801B - Command Quick Reference

Command Quick Reference
ABORt Subsystem
Command/Query Description
ABORt[:ALL] Aborts both TRANsient and ACQuire operations.
ABORt:ACQuire Aborts all ACQuire operations.
ABORt:TRANsient Aborts all TRANsient actions.
CALibrate Subsystem
Command/Query Description
CALibrate:COUNt? Returns the calibration count.
CALibrate:CURRent:OFFSet <value> Starts the DC current limit calibration for the specified voltage range.
CALibrate:DATA <value> Enters the calibration value read from a multimeter.
CALibrate:DATE "<date>"
CALibrate:DATE?
Sets the calibration date.
CALibrate:LEVel P1|P2|P3|P4|P5 Advances to the next calibration point.
CALibrate:PASSword "<password>" Sets the Admin password, which is used for calibration.
CALibrate:SAVE Saves the calibration data and date, not the administration password, into nonvolatile
memory.
CALibrate:STATe ON|1|OFF|0 [,<pass-
word>]
CALibrate:STATe?
Enables or disables calibration mode.
CALibrate:VOLTage[:LEVel] <value> Selects the AC voltage range to calibrate.
CALibrate:VOLTage:OFFset <value> Selects the DCvoltage range to calibrate.
CURRent Subsytem
Command/Query Description
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <value>|MINim-
um|MAXimum
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]? [MINimum|MAXimum]
Sets the immediate AC current limit in amps
(rms).
[SOURce:]CURRent:OFFSet[:IMMediate] <value>|MINimum|MAXimum
[SOURce:]CURRent:OFFSet[:IMMediate]? [MINimum|MAXimum]
Sets the immediate DC current limit in amps.
[SOURce:]CURRent:PROTection:STATeON|1|OFF|0
[SOURce:]CURRent:PROTection:STATe?
Enables or disables current protection.
3SCPI Programming Reference
106 Keysight AC6800B Series Operating and Service Guide