Quick Start
Turn the Unit On and Off
Use the Menu System
Enter Numeric and Alphanumeric Values
Set the Output Voltage
Set the Output Current Limit
Enable the Output
Use Built-in Help System
Turn the Unit On and Off
To turn the instrument on:
1. Check that the power switch is turned off (O) and that nothing is connected to any output terminal
block on the instrument.
2.
Check that the power cord is of the correct type and correctly connected.
3. Push the (l) side of the power switch. If any unusual sound, unusual odor, fire, or smoke is perceived,
remove the power plug from the outlet or turn off the switchboard.
4.
The display lights up after a few seconds. An automatic power-on self-test ensures that the instrument
is operational.
It takes about 10 seconds for the instrument to initialize before it is ready for
use.
If the instrument does not turn on, verify that the power cord is firmly connected (power-line voltage is
automatically sensed at power-on). Also make sure that the instrument is connected to an energized
power source. If the LED next to the power switch is off, there is no AC power connected. If the LED is
amber, the instrument is in standby mode with AC power connected, and if it is green, the instrument
is on.
If a self-test error occurs, a message is displayed on the front panel. For other self-test errors, see
Service and Maintenance for instructions.
Push the (O) side of the POWER switch to turn the instrument off.
Keysight AC6800B Series Operating and Service Guide 35
1îîGetting Started
To Next Page
Loading...