Keysight Technologies AC6801B - Page 154

SYSTem:SSAVer[:STATe] ON|1|OFF|0
SYSTem:SSAVer[:STATe]?
Enables or disables the screen saver.
Parameter Typical Return
ON|1|OFF|0 0(OFF)or1(ON)
Turn the screen saver off: SYST:SSAV OFF
This parameter is not affected by *RST or *RCL.
This parameter is not affected by power cycling.
SYSTem:SSAVer:DELay <seconds>|MINimum|MAXimum
SYSTem:SSAVer:DELay? [MINimum|MAXimum]
Sets the delay time for screen saver activation. The value is the time since the last front-panel access
or the last access since remote (with remote wake-up enabled).
Parameter Typical Return
Integer from 60 to 59940 +6.60000E+02
Set the delay to five minutes: SYST:SSAV DEL 300
This parameter is not affected by *RST or *RCL.
The unit is in seconds, but the value will be rounded to a the nearest minute. For example, a setting of
100 s will be rounded to 120 s (exactly two minutes).
This parameter is not affected by power cycling.
SYSTem:SSAVer:RWAKeup ON|1|OFF|0
SYSTem:SSAVer:RWAKeup?
Enables or disables remote screen saver wake-up.
Parameter Typical Return
ON|1|OFF|0 0(OFF)or1(ON)
Enable remote screen saver wake-up: SYST:SSAV:RWAK ON
When this feature is on, the screen saver is never activated as long as remote IO is operating and will
wake-up by a remote access if the screen saver is active.
This parameter is not affected by *RST or *RCL.
This parameter is not affected by power cycling.
3SCPI Programming Reference
154 Keysight AC6800B Series Operating and Service Guide