46
A`. Measurement Procedure: Ic-Vce(Power BJT) Application Test,
- Starting from pre-defined test setup of My favorite Setup
This test approach starts measurements by using a pre-defined test setup saved in
My favorite Setup instead of starting from a scratch by using an Application Test
Library.
Setup and execute the test by following the next steps. The same instruction steps
are illustrated by the numbers on the "1`. Starting from Application Test Library"
side of figure 3-5.
Step 1. Click the Preset group of My Favorite Setup.
Step 2. Select Example_AT preset group.
Step 3. Select Ic-Vce(PowerBJT) (Click the Ic-Vce(PowerBJT)).
Step 4. Click "Recall" button.
Next step: Go to step 5 of "Starting from Application Test Library" above, and con-
tinue by following the test step numbers.
To Next Page
Loading...
