Gateway
A gateway is a network device that connects networks. The default gateway setting is the IP address of such a
device.
– You need not set a gateway address if using DHCP.
– Contact your LAN administrator for details.
– This setting is non-volatile; it will not be changed by power cycling or *RST.
1. Press Utilities > I/O Config > LAN Settings > Services > DHCP ON | OFF.
2. Press Back. Then press Addresses > Modify Gateway.
3. Select Gateway field using Previous and Next key. Set the appropriate gateway address.
4. Press Apply to save the setting.
DNS
DNS (Domain Name Service) is an Internet service that translates domain names into IP addresses. The DNS server
address is the IP address of a server that performs this service.
– Normally, DHCP discovers DNS address information; you only need to change this if DHCP is unused or not
functional. Contact your LAN administrator for details.
– This setting is non-volatile; it will not be changed by power cycling or *RST.
1. Press Utilities > I/O Config > LAN Settings > Services > Auto DNS ON | OFF to configure the addressing of the
instrument in DNS server automatically.
2. Press Utilities > I/O Config > LAN Settings > Services > Auto DNS ON | OFF to configure the addressing of the
instrument manually.
3. Press Back. Then press Addresses > Modify DNS1 or DNS2.
4. Select DNS1 address or DNS2 address using Previous and Next key. These fields only appear when Auto DNS is
set to Off.
5.
Set the desired primary and secondary address.
6. Press Apply to save the setting.
32
Keysight EDU36311A User's Guide
To Next Page
Loading...
Need help?
General
