Hostname
A hostname is the host portion of the domain name, which is translated into an IP address.
Each power supply is shipped with a default hostname with the format: Keysight-model number-serial number,
where model number is the power supply’s 9-character model number (e.g. EDU36311A), and serial number is the
last five characters of the 10-character power supply serial number located on the label on the top of the unit (e.g.
45678 if the serial number is MY12345678).
– The instrument receives a unique hostname at the factory, but you may change it. The hostname must be unique
on the LAN.
– The name must start with letter; other characters can be an upper or lower case letters, numeric digits, or dashes
("-").
– This setting is non-volatile; it will not be changed by power cycling or *RST.
1. Press Utilities > I/O Config > LAN Settings > Host Name.
2.
Enter the host name with the keyboard provided. See Using the virtual keyboard.
3. Press Apply to save the setting.
4. Press Clears All to cancel all the changes. Press Back to exit without saving.
mDNS Service
The mDNS service name is registered with the selected naming service.
Each power supply is shipped with a default service name with the format: Keysight-model number-serial number,
where model number is the power supply’s 9-character model number (e.g. EDU36311A), and serial number is the
last five characters of the 10-character power supply serial number located on the label on the top of the unit (e.g.
45678 if the serial number is MY12345678).
– The instrument receives a unique mDNS service name at the factory, but you may change it. The mDNS service
name must be unique on the LAN.
– The name must start with letter; other characters can be an upper or lower case letters, numeric digits, or dashes
("-").
1. Press Utilities > I/O Config > LAN Settings > Services >mDNS ON | OFF to configures the service name
registered with the selected naming service automatically.
2. Press Utilities > I/O Config > LAN Settings > Services > mDNS ON | OFF to configure the service name of the
instrument manually.
3.
Select mDNS Service field using the navigation keys.
4. Press mDNS Service and enter the service name with the keyboard provided. See Using the virtual keyboard.
5. Press Apply to save the setting.
6. Press Clears All to cancel all the changes. Press Back to exit without saving.
Keysight EDU36311A User's Guide 33
To Next Page
Loading...
Need help?
General
