44 Keysight M8040A High-Performance BERT Getting Started Guide
2 Basic Setup for M8040A
Imadmin Installation
The following procedure describes how to install lmadmin.exe (server
side):
1Copy the agilent.lic file from the Keysight Licensing installation path
(typically found in, C:\Program Files\Agilent\ACCL\Licensing\bin or
C:\Program Files (x86)\Agilent\\ACCL\Licensing\bin) into the licensing
folder. (The license filename will change to agilent0.00.lic after
successful installation.)
2 Determine whether the target system has Java installed, if not, install
it from www.java.com. The Java virtual machine is required to run the
lmadmin.exe installer.
3 Run the lmadmin.exe. (Right-click the installer file and Run as
Administrator.) During the installation:
1 Accept the default installation path.
2 Check the box to Install Visual C++ 2005 SP1 Redistributable.
3 On the Service Configuration page, enter the HTTP Port Number:
‘8090’.
4 On the Service Configuration page, select the check-box to Run as
Service.
5 On the Start the Server page, select the check box to Start server
now. If you don't do it now, then you will need to start the lmadmin
service before configuring the license server.
4If the web browser does not shows the license configuration page, just
exit the browser and reboot the PC.
5 After reboot start the browser and use the use following
http://localhost:8090/ address again.Now you should see the web
configuration page of the lmadmin.
6 However, if you see the message ‘The page can’t be displayed …’ again
the firewall of windows has block the access. You may need to allow
certain executable and/or the port number to go through the firewall.
For firewall settings, refer to Firewall Configuration for Licensing on
page 42.
7 In the login page, if you have not previously set up a login, sign in as
“user admin” with password “admin”. You will then be required to
change the password.
8 Start the browser and use the use following http://localhost:8090/
address again.
9The lmadmin is installed as service. To check the state of the service,
right click on the Computer icon on the desktop and then select
Manage. Click on Services and check if service lmadmin is started.
To Next Page
Loading...
Need help?
General
