Keysight Agile Signal Generator Service Guide 105
Assembly Replacement
7. Refer to Figure 3-8. Using the T-20 driver, remove the six screws (1)
(0515-2044).
Figure 3-8 Front Frame Removal
The six screws that attach the front frame to the chassis are recommended to be one-time use
only hardware. These should be replaced with the new screws (0515-2044) if available. These
screws are provided in the front panel replacement kit.
Before removing the front frame from the signal generator, lift and support the front of the signal
generator chassis.
To Next Page
Loading...
