331
Keysight Handheld Analyzers
N99xxA User’s Guide
16 Built-in Power Meter Mode – Option 310
Built-in Power Meter (also known as Channel Power Meter) uses the SA input
connector to make quick and simple power measurements over a selectable
frequency band. A power sensor is NOT required.
In this Chapter
See Also
The following Built-in Power Meter settings are identical to the standard Power
Meter settings:
“Frequency/ Span / Step” on page 333
“Radio Standard” on page 334
“How to set Attenuation” on page 334
“Scale” on page 341
“Relative and Offset Power Measurements” on page 342
“Display Units” on page 342
“Averaging” on page 343
“Single or Continuous Measure” on page 343
To Next Page
Loading...
Need help?
General
