Keysight N9927-90001 User’s Guide 519
System Settings
Display
a constant, uninterrupted RF output from the RF OUT port. This
behavior also provides the highest trace stability sweep-to-sweep
which may only be evident while using either single sweep or
Run/Hold. With Battery Saver OFF, the use of a full battery charge is
reduced by approximately 45 minutes.
Startup Mode
The Startup Mode setting determines the mode that becomes active (visible)
when User Preset is set to OFF (Factory Preset) and the FieldFox is powered
ON. See “User Preset” on page 511.
How to setup Startup Mode
—Press System 7
—Then Preferences
—Then Preferences
— Then scroll to Global Settings > Startup Mode and press Edit.
— Then repeatedly press the Startup Mode
to scroll through the available
choices.
— <Default>
is the factory default mode for your FieldFox model.
— Built-in Power Meter Mode is NOT allowed as a Startup Mode.
Display
Choose the Display values (Display Colors, Trace Width, Brightness, Title
Enabled, Title). See “Display (Settings)” on page 513.
How to select Display values:
—Press System 7
—Then Preferences
—Then Preferences
— Then use arrow softkeys or the knob to select Display
—Then Edit
for each of the following:
—Display Colors
—Indoor (default)
—Night Vision
—Outdoor Sun
—Outdoor Dusk
To Next Page
Loading...
Need help?
General
