Keysight N9927-90001 User’s Guide 533
System Settings
System Configuration
— Clear Overload If the voltage source becomes ‘TRIPPED’ press to re-enable
the voltage source output. Then set Source ON
.
— Status Line ON OFF
Turn ON and OFF the voltage source status line that
appears near the top of the screen. The status line is always ON while
making Voltage Source settings.
Security Level
For security reasons, you can prevent frequency information from appearing on
the FieldFox while in SA, NA, or CAT modes.
How to set Security Level
—Press System 7
—Then System Configuration
—Then Security Level
— Then choose from the following:
— None
All frequency settings are visible.
— High
Frequency information is blanked from the following:
——Display annotation
——Softkeys
——Marker display and marker table
——Calibration properties
——All settings tables
——Limit line tables
——All saved.png files
— Any of the following will re-display frequency information:
——Set to None
, Preset, Mode Preset, or FieldFox restart.
Date and Time, Format, and Time Zone Settings
Set the local date and time, Date and Time format, and Time Zone that is
shown on the FieldFox screen. The Date and Time is also used to identify files
that are saved.
The Date and Time can also be set by synchronizing with GPS satellites. Learn
more in “GPS – Distance Settings” on page 521.
How to Update Date and Time using Internet
This method of setting the Date and Time does NOT have the security
restrictions of the other methods (listed below).
To Next Page
Loading...
Need help?
General
