Keysight InfiniiVision 2000 X Series User Manual

63
Keysight InfiniiVision 2000/3000 X-Series Oscilloscope
Service Guide
4 Troubleshooting
Solving General Problems with the Oscilloscope / 64
Verifying Basic Operation / 66
This chapter begins with “Solving General Problems with the Oscilloscope. It tells
you what to do in these cases:
• If there is no display.
• If there is no trace display.
• If the trace display is unusual or unexpected.
• If you cannot see a channel.
Next, this chapter describes procedures for “Verifying Basic Operation of the
oscilloscope:
• To power-on the oscilloscope.
• To perform hardware self test.
• To perform front panel self test.
• To verify default setup.
• To perform an Auto Scale on the Probe Comp signal.
• To compensate passive probes.
The service policy for all 2000/3000 X-Series oscilloscopes is now unit
replacement, so there are no longer internal assembly troubleshooting
instructions in this service guide.
Read All Cautions and Warnings
Before you begin any troubleshooting, read all Warning and Cautions in the “Troubleshooting” section.

Keysight InfiniiVision 2000 X Series Specifications

General

Brand	Keysight
Model	InfiniiVision 2000 X Series
Category	Test Equipment
Language	English