Keysight N777 C Series - Page 67

Keysight N777-C Series Tunable Laser Family User’s Guide 67
N777-C Web User Interface Reference 4
How to Set the Wavelength Sweep?
The Sweep Parameters
These are the parameters for the wavelength sweep:
• Sweep Mode - see How to Perform a Sweep? on page 69,
• Repeat mode - see How to Set the Repeat Mode? on page 68.
• Sweep Speed - the speed of a continuous sweep,
• Cycles - the number of times the sweep is repeated,
• Dwell - the amount of time spent at the wavelength during each step,
for a stepped sweep
• Sweep Start - the wavelength at which the sweep begins,
• Sweep Stop - the wavelength at which the sweep ends,
• Sweep Step - the size of the change in the wavelength for each step of
a sweep,
• Run/Stop Sweep - to run and start the sweep.