Keysight N9000B - 3.8.4 Results for n = 6

3 Short-Range Comms & IoT Mode
3.8 SEM Measurement
The length of the result depends on the number of available offset (See "Number of
Offsets" on page 1019)
k is an index for each offset: k = 0 for offset A; k = 1 for offset B; k = 2 for offset C, etc.
The number of offsets is 12 (A-L).
# Item
1 Depends on "Measurement Type" on page 1174:
–
Total power reference (dBm)
–
Power spectral density reference (dBm/Hz)
–
Spectrum peak power reference (dBm)
2 Reserved for future use, returns -999.0
3
2k + 3, k = 0
Power
(*1)
at negative offset A
4
2k + 4, k = 0
Power
(*1)
at positive offset A
---
26
2k + 4, k = 11
Power
(*1)
at positive offset L
*1: Absolute integrated power when "Measurement Type" on page 1174 is Total
Power Ref or PSD Ref; Absolute peak power when "Measurement Type" on page
1174 is Spectrum Peak Ref
3.8.4 Results for n = 6
When "Measurement Type" on page 1174 is Total Power Ref or PSD Ref, returns
comma-separated scalar values (in dBc or dBc/Hz) of the integrated power relative
to the carrier at the segment frequencies
When "Measurement Type" on page 1174 is Spectrum Peak Ref, returns comma-
separated scalar values (in dB) of the peak power relative to the carrier at the
segment frequencies
The length of the result depends on the number of available offset (See "Number of
Offsets" on page 1019)
For MSR, 5G NR, LTEAFDD, and LTEATDD Modes, returns outer offset results when
"Non-Contiguous Meas Region" on page 1096 is set to Outer or Outer & Inner
(5GNR, LTEAFDD, LTEATDD only), and returns inner offset results when it is set to
Inner
The results are in the following order:
1014 Short Range Comms & IoT Mode User's &Programmer's Reference