Keysight N9000B - Meas Preset; 3.11.8.2 Meas Standard; Radio Standard

3 Short-Range Comms & IoT Mode
3.11 IQ Waveform Measurement
–
Video BANDwidth VBW/RBW ratio
–
Upper and Lower Tone (set to Sense)
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all measurement parameters to their default values.
Remote Command
:CONFigure:WAVeform
Example
:CONF:WAV
Notes Restore default values of all parameters
3.11.8.2 Meas Standard
This tab contains controls for setting the standard based on which the current
measurement is made. The standards include ZigBee (IEEE 802.15.4), Z-Wave (ITU-
T G.9959), LoRa
TM
(CSS) and HRP UWB.
Certain measurements do not support all four standards (see the compatibility table
in "Radio Standard" on page 1711). When selecting a radio standard unsupported
by the current measurement, a warning indicating a conflict of settings will appear
on the user interface.
Radio Standard
Indicates the standard on which the measurement will be made. This parameter is
removed from the GUI controls as of XA25 and the SCPI command is kept for BWC.
1602 Short Range Comms & IoT Mode User's &Programmer's Reference