Keysight N9000B - Minimum Acquisition Time

3 Short-Range Comms & IoT Mode
3.8 SEM Measurement
Notes Comma separated list of values
OFFSet1 is for BTS, 2 for MS. Default is BTS
Note that Offset sub op code 2 is supported only in non-SA modes. In the SA mode, Offset sub op
code 1 is used for both BTS and MS
Dependencies On non-sweeping hardware, this column is grayed out and the Auto/Man checkbox is invisible. The
read-only value shows the estimated sweep time
In those instruments, "Minimum Acquisition Time" on page 1118 is available
Couplings When you manually set a value when in the Auto state, the state automatically changes to Man
Preset Automatically calculated
Modes other than LTEAFDD, LTEATDD, 5G NR, MSR, WLAN:
When the max number of offsets is 6:
ON,ON,ON,ON,ON,ON
When the max number of offsets is 12:
ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON
Modes LTEAFDD, LTEATDD, 5G NR, MSR:
ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON | ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON
When the max number of offsets is 14:
Mode WLAN:
ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON
State Saved Saved in instrument state
Saved in instrument state
Range Auto|Man
Min Other than non-sweeping hardware
Depends on Sweep Type:
–
Sweep Type “Swept”: 1 ms
–
Sweep Type “FFT”: 100 ns
Non-sweeping hardware: N/A
Max Other than non-sweeping hardware: 4000 s
Non-sweeping hardware: N/A
Backwards
Compatibility SCPI
[:SENSe]:SEMask:OFFSet[1]|2:LIST:SWEep[:TIME]
[:SENSe]:SEMask:OFFSet[1]|2:LIST:SWEep[:TIME]:AUTO
Minimum Acquisition Time
Available on non-sweeping hardware.
Specifies the minimum acquisition time for each “chunk” of the measurement result.
The instrument automatically divides Span into multiple chunks if needed.
1118 Short Range Comms & IoT Mode User's &Programmer's Reference