Keysight N9000B - PHR;PSDU Parameters; Hop Bursts; Chips per Burst

3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
PHR/PSDU Parameters
Hop Bursts
Sets the number of hopping burst locations in each half of a BPM-BPSK symbol.
Remote Command
[:SENSe]:HUWB:DATA:HBURsts <integer>
[:SENSe]:HUWB:DATA:HBURsts?
Example
:HUWB:DATA:HBUR 8
:HUWB:DATA:HBUR?
Couplings There are only three valid values: 2, 8, 32
Available when "PHY Mode" on page 501 is Non-ERDEV or ERDEV-BPRF
When PHY Mode is ERDEV-BPRF, the value is fixed at 2
Preset 8
State Saved Saved in instrument state
Min 2
Max 32
Chips per Burst
Sets the number of chips in each burst.
Remote
Command
[:SENSe]:HUWB:DATA:BCHips <integer>
[:SENSe]:HUWB:DATA:BCHips?
Example
:HUWB:DATA:BCH 128
:HUWB:DATA:BCH?
Couplings Available when "PHY Mode" on page 501 is Non-ERDEV or ERDEV-BPRF
PHY Mode Hop Bursts Valid Values
ERDEV-BPRF The value is fixed at 8
Non-ERDEV 2 2, 8, 64, 512
8 1, 2, 16, 128
32 1, 2, 4, 32
Preset 128
State Saved Saved in instrument state
Min 1
Max 512
Short Range Comms & IoT Mode User's &Programmer's Reference 511