3 Short-Range Comms & IoT Mode
3.7 ACP Measurement
3.7.13.4 Advanced
Contains controls for setting advanced functions of the instrument.
This tab does not appear in the following instruments:
–
EXM
–
VXT model M9420A
Phase Noise Opt
Selects the LO (local oscillator) phase noise behavior for various operating
conditions.
Remote Command
[:SENSe]:ACPower:FREQuency:SYNThesis[:STATe] 1 | … | 5
For the meaning of each numeric option value, see "Parameter Options, Installed Options, Auto Rules
& Ranges" on page 960 below
[:SENSe]:ACPower:FREQuency:SYNThesis[:STATe]?
Example
:ACP:FREQ:SYNT 1
:ACP:FREQ:SYNT?
Dependencies Does not appear in all models. For models that do not display this control, the SCPI command is
accepted for compatibility (although no action is taken)
Not available in VXT models M9410A/11A/15A
Preset Because this function is in Auto after preset, the state of this function after Preset will be automatically
calculated
State Saved Saved in instrument state
Range See "Ranges" on page 964 below
Auto Function
Remote
Command
[:SENSe]:ACPower:FREQuency:SYNThesis:AUTO[:STATe] OFF | ON | 0 | 1
[:SENSe]:ACPower:FREQuency:SYNThesis:AUTO[:STATe]?
Short Range Comms & IoT Mode User's &Programmer's Reference 959
To Next Page
Loading...
