Keysight N9000B - 3.4.8.6 Advanced; Phase Noise Optimization

3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
Preset 30%
State Saved Yes
Min 0%
Max 100.0%
3.4.8.6 Advanced
Lets you configure advanced parameters.
Phase Noise Optimization
Enables you to select the LO (local oscillator) phase noise behavior for various
desired operating conditions.
For full details, see "Parameter Options, Installed Options & Auto Rules" on page
521 and "Ranges" on page 526 below.
Remote
Command
[:SENSe]:HUWB:FREQuency:SYNThesis[:STATe] 1 | … | 5
For the meaning of each numeric option value, see "Parameter Options, Installed Options & Auto Rules"
on page 521 below
[:SENSe]:HUWB:FREQuency:SYNThesis[:STATe]?
Example
:HUWB:FREQ:SYNT 2
Selects optimization for best wide offset phase noise
Preset 2
State Saved Yes
Range See "Ranges" on page 526 below
Min/Max 1/5 instruments with EP0
1/3 instruments without EP0
Parameter Options, Installed Options & Auto Rules
The Phase Noise Optimization control lets you optimize the setup and behavior of
the Local Oscillator (LO) depending on your specific measurement conditions. You
may wish to trade off noise and speed, for example, to make a measurement faster
without regard to noise or with optimum noise characteristics without regard to
speed.
Parameter Values Summary
Option # Description
"Balanced" on
page 523
1
–
In instruments with EP0, balances close-in phase noise with spur
avoidance
Short Range Comms & IoT Mode User's &Programmer's Reference 521