3 Short-Range Comms & IoT Mode
3.6 Power Stat CCDF Measurement
–
"Center Frequency Presets" on page 745
–
"VXT Models with Radio Heads/CIU Frequency Range" on page 747
–
"RF Center Freq" on page 747
–
"Ext Mix Center Freq" on page 748
–
"I/Q Center Freq" on page 748
Remote
Command
[:SENSe]:FREQuency:CENTer <freq>
[:SENSe]:FREQuency:CENTer?
Example Set Center Frequency to 50 MHz:
:FREQ:CENT 50 MHz
Increment Center Frequency by the value of CF Step:
:FREQ:CENT UP
Return the current value of Center Frequency:
:FREQ:CENT?
Notes Sets the RF, External Mixing or I/Q Center Frequency depending on the selected input:
–
For RF input it is equivalent to :FREQ:RF:CENT
–
For I/Q input it is equivalent to :FREQ:IQ:CENT
–
For External Mixer it is equivalent to :FREQ:EMIX:CENT
Preset and Max values are dependent on Hardware Options
If no terminator (for example, MHz) is sent, the terminator Hz is used. If a terminator with unit other
than Frequency is used, an invalid suffix error message is generated
Preset Depends on instrument maximum frequency, mode, measurement, and selected input
See "Center Frequency Presets" on page 745, "RF Center Freq" on page 747, "Ext Mix Center Freq" on
page 748, "I/Q Center Freq" on page 748, and "VXT Models with Radio Heads/CIU Frequency Range"
on page 747
State Saved Saved in instrument state
Min/Max Depends on instrument maximum frequency, mode, measurement, and selected input
See "Center Frequency Presets" on page 745, "RF Center Freq" on page 747, "I/Q Center Freq" on
page 748, and "VXT Models with Radio Heads/CIU Frequency Range" on page 747
Status Bits/OPC
dependencies
Non-overlapped
The following command and parameters apply only to MSR, LTE-Advanced
FDD/TDD and 5G NR Modes.
Remote Command
[:SENSe]:FREQuency:CENTer:AUTO ON | OFF | 1 | 0
[:SENSe]:FREQuency:CENTer:AUTO?
744 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
