Command Reference
Spectrum Monitor Option Subsystem
128
Use this command to set the frequency of marker in
spectrogram measurement.
Example: :SPECtrogram:MARKer2:FREQuency 1GHz
Key access: Marker > Frequency
Spectrogram Marker Time
[:SENSe]:SPECtrogram:MARKer[1]|2:TIME <value>
[:SENSe]:SPECtrogram:MARKer[1]|2:TIME?
Use this command to locate the marker to specific time
point in spectrogram measurement.
Example: :SPECtrogram:MARKer1:TIME 1 ks
Key access: Marker > Time
Spectrogram Marker Peak Search
[:SENSe]:SPECtrogram:MARKer[1]|2:PEAK
Use this command to perform Marker peak search once.
Example: :SPECtrogram:MARKer1:PEAK
Key access: Marker > Peak Search
Spectrogram Marker Previous Failure Search
[:SENSe]:SPECtrogram:MARKer[1]|2:FAIL:PRE
Use this command to locate Marker to the previous fail trace
(frame) in spectrogram measurement result.
Example: :SPECtrogram:MARKer1:FAIL:PRE
Key access: Marker > Failed Frame Search
Spectrogram Marker Next Failure Search
[:SENSe]:SPECtrogram:MARKer[1]|2:PEAK
Use this command to locate Marker to the next fail trace
(frame) in spectrogram measurement result.
Example: :SPECtrogram:MARKer1:FAIL:NEXT
Key access: Marker > Failed Frame Search
To Next Page
Loading...
