Keysight N9322C - Page 149

141
Command Reference
Reflection Measurement Option Subsystem
Reflection Measurement Trace Data Query
:TRACe[:DATA]? DATA|MEM
Use this command to query the current trace data.
Example: :TRACe? DATA
Reflection Measurement Sweep Continuos State
:INITiate:CONTinuous OFF|ON|0|1
:INITiate:CONTinuous?
Use this command to turn on/off continuos sweep state of
current test.
Example: :INITiate:CONTinuous 1
Key access: Shift > Sweep> Sweep > Single / Cont
Reflection Measurement Single Sweep
:INITiate[:IMMediate]
Use this command to perform single sweep once.
Example: :INITiate
Key access: Shift > Sweep> Sweep > Single Sweep
Reflection Measurement Marker All Off
:CALCulate:MARKer:AOFF
This command turns off all the Marker displayed on screen.
Example: :CALCulate:MARKer:AOFF
Key access: Marker > More 1 of 2 > All Off
Reflection Measurement Marker Mode
:CALCulate:MARKer[1]|2|3|4|5|6:MODE
OFF|POSition|DELTa
:CALCulate:MARKer[1]|2|3|4|5|6:MODE?
This command toggles the marker mode in CAT test.
Example: :CALCulate:MARKer1:MODE DELTa
Key access: Marker > Normal/Delta/Off