Keysight N9322C - Page 160

Command Reference
Channel Scanner Option Subsystem
152
Channel Scanner Edit Subsection
Set Channel Edit Method for List Sweep
:CHSCanner:EDIT:LIST:METHod
<index>,<0|1>{,<index>,< 0|1>}
:CHSCanner:EDIT:LIST:METHod?
This command specify the channel edit method for list
sweep. In list sweep mode, there are two method to insert
or edit a scan channel, custom method and signal standard
method. Custom method requires to insert or edit a scan
channel by inputting the center frequency and bandwidth of
channel, and signal standard method requires to choose the
signal standard and channel ID from built- in signal standard
list.
Remarks: Parameter <0|1> indicate <Custom | Standard>
Example: :CHSCanner:EDIT:LIST:METHod 1,0,3,1
Key access: Meas > List Edit > Insert > Edit Method
Add Channel By Custom For List Sweep
:CHSCanner:EDIT:LIST:ADD:CUSTom
<freq>,<bandwidth>{,<freq>,<bandwidth>}
This command adds custom scan channels to the sweep list
of List Sweep Mode.
Example: :CHSCanner:EDIT:LIST:ADD:CUSTom
10000000,1000000,20000000,10000
Key access: Meas > List Edit > Insert > Edit Method > Custom
Add Channel By Signal Standard for List Sweep
:CHSCanner:EDIT:LIST:ADD:STD <signal std.>,<ch.
no>{,<signal std.>,<ch. no>}
This command adds scan channels according to the build- in
signal standard. The address of build- in signal stand file is
“d:/”.