Keysight N9322C - Page 167

159
Command Reference
Channel Scanner Option Subsystem
Set Custom Scan Channel Quantity For Bottom N Sweep
:CHSCanner:EDIT:BOTTom:CUSTom:CHNumber <value>
:CHSCanner:EDIT:BOTTom:CUSTom:CHNumber?
This command defines custom scan channel quantity for
Bottom N sweep mode.
Example: :CHSCanner:EDIT:BOTTom:CUSTom:CHNumber 200
Key access: Meas > Range Edit > Edit Method Custom, then > Number of Chn
Channel Scanner Display Subsection
Display Switch
:CHSCanner:DISPlay[:STATe] RUN|STOP
:CHSCanner:DISPlay[:STATe]?
This command toggles channel scanner display state between
freeze and refresh. Freeze state stops channel scanning
operation, and Refresh state runs channel scanning
operation.
Example: :CHSCanner:DISPlay RUN
Key access: Shift > Disp > Freeze/Refresh
Display Mode
:CHSCanner:DISPlay:MODE TABLe|CHARt
:CHSCanner:DISPlay:MODE?
This command toggles display mode between table mode and
time chart mode. The time chart mode is only available for
List sweep mode.
Example: :CHSCanner:DISPlay:MODE CHARt
Key access: Shift > Disp > Disp Mode